Error Troubleshooting
Phaser 7100 Service Manual Xerox Internal Use Only2-460
Ethernet Port Verification for LOCAL LINK Default IP Addresses
An alternate method is required to test the Ethernet port when the PC’s IP address falls within the
range 169.254.xxx.xxx. PCs that have not been configured for a specific network default to a “LOCAL
LINK” value within the 169.254.xxx.xxx range.
Notes:
• To comply with industry standards, Phaser products cannot be manually configured for
IP addresses within the LOCAL LINK range.
• Always print the Configuration page to obtain a record of the printer settings before
changing the IP address. After testing the printer, be sure to restore the printer’s original
network settings.
1. Connect a crossover cable between the PC and printer.
2. Verify the printer is Ready.
3. Use the printer’s Control Panel to enable AutoIP:
a. From the Control Panel, press Menu.
b. Press Down Arrow and navigate to Admin Menu, and press OK.
c. Press Down Arrow and navigate to Network/ Port, and press OK.
d. Press Down Arrow and navigate to TCP/ IP Settings, and press OK.
e. Press Down Arrow and navigate to IPv4 Settings, and press OK.
f. Press Right Arrow to display the Get IP Address screen.
g. Press Down Arrow and navigate to DHCP/ Auto IP, and press OK.
h. Press Menu to return to the Ready to Print screen.
4. After the printer’s IP address is set, test communication by sending the “PING” command.
5. If the test fails, install a different cable and retest.
To Next Page
Loading...
Need help?
General
