Xerox Phaser 7100

Error Troubleshooting
Phaser 7100 Service Manual Xerox Internal Use Only2-332
116-332 ESS Standard ROM Error
An ESS On Board Standard ROM error was detected.
Applicable Fault Code
• 116-332: ESS On Board ROM Error
Initial Actions
• Power cycle the printer.
• If the problem persists, perform the following procedure
.
Troubleshooting Reference
Applicable Parts Wiring and Plug/Jack Map References
• Image Processor PWB, PL 12.4.1
Troubleshooting Procedure
Step Actions and Questions
1. Remove and reinstall the Standard ROM (REP 12.18 Memory (Standard) on page 4-232) on the I/P
PWB.
2. If the problem persists, replace the I/P PWB (REP 12.17 Image Processor (I/P) PWB on page 4-228).