Service Parts Disassembly
Xerox Internal Use Only Phaser 7100 Service Manual 4-221
REP 12.13 HVPS1 PWB
PL 12.2.15
CAUTION: PWB’s can be damaged by an electrostatic discharge. Observe all ESD procedures to
avoid component damage.
1. Remove the I/P PWB Cover Assembly (REP 1.5 Image Processor (I/P) PWB Cover Assembly on
page 4-19).
2. Remove the Rear Cover (REP 1.6 Rear Cover on page 4-20).
3. Remove the Right Side Cover (REP 1.11 Right Side Cover on page 4-27).
4. Remove the Image Processor PWB (REP 12.17 Image Processor (I/P) PWB on page 4-228).
5. Remove 5 screws (silver, 6 mm) that secure the Rear Frame Assembly to the printer.
6. Free the Rear Frame Assembly upwards together with the harness that is attached underneath it.
To Next Page
Loading...
