Xerox Phaser 7100

Error Troubleshooting
Xerox Internal Use Only Phaser 7100 Service Manual 2-349
116-377 Video DMA Fail
Video DMA failure was detected.
Applicable Fault Codes
• 116-377: Video DMA Fail
Initial Actions
• Power cycle the printer.
• If the problem persists, perform the following procedure
.
116-380 ESS Font ROM DIMM #1 Check Fail
En error was detected at the ESS Font ROM DIMM #1 check.
Applicable Fault Code
• 116-380: ESS Font ROM DIMM #1 Check Failure
Initial Actions
• Power cycle the printer.
• If the problem persists, perform the following procedure
.
Troubleshooting Procedure
Step Actions and Questions
1. Turn the printer power Off and On and check whether the problem is reoccurring.
If the problem persists, go to Common System Fail on page 2-406.
Troubleshooting Reference
Applicable Parts Wiring and Plug/Jack Map References
• Image Processor PWB, PL 12.4.1
Troubleshooting Procedure
Step Actions and Questions
1. Remove and reinstall the I/P PWB (REP 12.17 Image Processor (I/P) PWB on page 4-228).
Replace the I/P PWB (REP 12.17 Image Processor (I/P) PWB on page 4-228).