Parts List
Phaser 7100 Service Manual Xerox Internal Use Only5-2
Serial Number Format
Changes to Xerox products are made to accommodate improved components as they become
available. It is important when ordering parts to include the following information:
• Component's part number
• Product type or model number
• Serial Number of the printer
The serial numbers are only reset to the starting serial number when the ending serial number is
reached. At that time the revision digit will be rolled. Serial numbers below 10001 are reserved for XOG
Final Integration Center (FIC) sites if reserialization is needed.
The serial numbers are only reset to the starting serial number when the ending serial number is
reached. At that time the revision digit will be rolled. Serial numbers below 10001 are reserved for XOG
Final Integration Center (FIC) sites if reserialization is needed.
Note: Not all of the serial number will be used. This is a buffer in case additional units are built by
Fuji Xerox for each model of printer during pre-production.
110V Engine Format
The nine-digit serial number has the following format:
• PPPSSSSSS
• PPP = Three digit alphanumeric product code
• SSSSSS = Six digit numeric serial number
Table 1: 110V Engine Format
Product Product Code Starting Serial Number Ending Serial Number
Pre-Production (PP)
7100_DN, 110V Engine XP6 002501 002700
Mass Production (MP)
7100_DN, 110V Engine XP6 003201 012500
*
Not all of the serial numbers will be used. This is a buffer in case additional units are built by FX during pre-
production
*
Serial numbers between 002701 - 003200 are reserved for XOG FIC sites if reserialization is needed. A serial
number break or a new serial number range will be provided when a major product change occurs.
To Next Page
Loading...
Need help?
General
