Error Troubleshooting
Xerox Internal Use Only Phaser 7100 Service Manual 2-331
116-331 Invalid Log Info
Log related error was detected.
Applicable Fault Code
• 116-331: Log Management Information Incorrect The detection area is the NVM log
management information area, the same as for NVM Fail.
Initial Actions
• Power cycle the printer.
• If the problem persists, perform the following procedure
.
Troubleshooting Reference
Applicable Parts Wiring and Plug/Jack Map References
• HDD Productivity Kit, PL 12.4.20
Troubleshooting Procedure
Step Actions and Questions
1. Remove the HDD (REP 12.21 Hard Disk Drive (Optional) on page 4-236).
Turn the printer power On then Off.
Reinstall the HDD and turn the printer power On.
2. If the problem persists, go to HDD System Fail on page 2-408.
To Next Page
Loading...
