Service Parts Disassembly
Phaser 7100 Service Manual Xerox Internal Use Only4-52
REP 2.13 No Paper Sensor
PL 2.2.2
1. Remove Tray 1.
2. Remove the Bypass Tray Frame Assembly (REP 3.1 Bypass Tray Frame Assembly on page 4-69).
3. Remove the I/P PWB Cover Assembly (REP 1.5 Image Processor (I/P) PWB Cover Assembly on
page 4-19).
4. Remove the Rear Cover (REP 1.6 Rear Cover on page 4-20).
5. Remove the Right Side Cover (REP 1.11 Right Side Cover on page 4-27).
6. Remove the Right Feeder Cover (REP 2.3 Right Feeder Cover on page 4-40).
7. Remove the Protect Cover Assembly (REP 2.7 Protect Cover Assembly on page 4-44).
8. Remove the Right Turn Bracket Assembly (REP 2.4 Right Turn Bracket Assembly on page 4-41).
9. Remove the Feeder Assembly (REP 2.1 Feeder Assembly on page 4-37).
10. Disconnect the wiring harness connector P/J4652A.
11. Release the hooks that secure the No Paper Sensor and remove the Sensor.
To Next Page
Loading...
