Xerox Phaser 7100 Service Manual

General and Operation Overview
Phaser 7100 Service Manual Xerox Internal Use Only1-60
Fuser Assembly (Fusing/ Paper Output)
The Fuser Assembly fuses the complete toner image that was transferred onto the paper, using heat
and pressure. The paper output section is also included in the Fuser Assembly. The Fuser Assembly is
made up of the following main components:
• Heat Roller - A tube-covered hollow metal roller, which applies heat to the paper to fuse the toner.
• Pressure Belt - A belt that contains a pressure system within it. This pairs up with the Heat Roller
and applies pressure to the paper to fuse the toner.
• Main Heater Lamp - A Lamp located inside the Heat Roller that heats the left and right ends of
the Heat Roller.
s7100-192
Heat Roller
Pressure Belt
Main Heater Lamp
Sub Heater Lamp
Center Temperature Sensor
Rear Temperature Sensor
Thermostat
Fuser PWB
Fuser Unit Exit Sensor
Fuser Unit Assembly

Xerox Phaser 7100 Specifications

General

Maximum Print Resolution	1200 x 1200 dpi
Monthly Duty Cycle	Up to 52, 000 pages
Processor	667 MHz
Memory (Standard)	256 MB
Paper Input Capacity (Maximum)	2, 050 sheets
Paper Output Capacity	250 sheets
Duplex Printing	Automatic
Type	Color Laser Printer
Operating System Compatibility	Windows, Mac OS, Linux
Connectivity	USB 2.0, Ethernet
Supported Media Sizes	A4, A5, B5, Letter, Legal
First Page Out (Black)	9 seconds
First Page Out (Color)	9 seconds
Print Languages	PCL 6, PostScript 3
Network Connectivity	Ethernet
Print Speed	Up to 30 ppm