Error Troubleshooting
Phaser 7100 Service Manual Xerox Internal Use Only2-90
Cont SEEP-ROM Diagnostic Fail-1
Unable to obtain the Product ID.
Applicable Fault Code
• 016-350: Cont SEEP-ROM Diagnostic Fail-1
Initial Actions
• Power cycle the printer.
• If the problem persists, perform the following procedure
.
Troubleshooting Reference
Applicable Parts Wiring and Plug/Jack Map References
• I/P PWB, PL 12.4.1
Troubleshooting Procedure
Step Actions and Questions
1. Check the SEEP ROM contacts (for bent and broken pins, etc.).
2. Replace the I/P PWB (REP 12.17 Image Processor (I/P) PWB on page 4-228).
To Next Page
Loading...
