Xerox Phaser 7100 Service Manual

Error Troubleshooting
Xerox Internal Use Only Phaser 7100 Service Manual 2-103
XPS Error
During the XPS Bridge process, invalid schema, parameter error, XPS file damage, or XPS decomposer
internal error has occurred.
Applicable Fault Code
• 016-514: XPS Error
Initial Actions
• Power cycle the printer.
• If the problem persists, perform the following procedure
.
XPS Short of Memory
Insufficient memory was detected during XPS Bridge process.
Applicable Fault Code
• 016-515: XPS Short of Memory
Initial Actions
• Power cycle the printer.
• If the problem persists, perform the following procedure
.
Troubleshooting Procedure
Step Actions and Questions
1. Print from the XPS Viewer using the Print Driver (ART-EX, PCL, etc.).
2. If the problem persists, go to Common Job Fail on page 2-407.
Troubleshooting Procedure
Step Actions and Questions
1. If the Print Mode is High Quality, change it to Normal. If it is Normal, change it to High Speed.
2. If the problem persists, increase the memory.
3. If the problem still occurs despite having increased the memory to the maximum, use the driver (ART-
EX, PCL, etc.) from the XPS Viewer to print.

Xerox Phaser 7100 Specifications

General

Brand	Xerox
Model	Phaser 7100
Category	Printer
Language	English