Xerox Phaser 7100

Error Troubleshooting
Xerox Internal Use Only Phaser 7100 Service Manual 2-275
Option Feeder Mode Fail
The Option Feeder error has occurred.
Applicable Fault Code
• 077-328: Option Feeder Mode Fail
Initial Actions
• Power cycle the printer.
• If the problem persists, perform the following procedure.
Duplex Wait Sensor On Jam/ IOT Static Jam
The following jam error has occurred due to one of the following problems.
•Jam clear
• Jam has occurred due to stationary, remaining paper that is not supported by the transport
control.
Applicable Fault Codes
• 077-907: Dup Wait SNR On Jam <Standby Jam>
• 077-909: IOT Static Jam (Not Paper Hand)
Troubleshooting Reference
Applicable Parts Wiring and Plug/Jack Map References
• Feeder PWB, PL 15.2.33
Troubleshooting Procedure
Step Actions and Questions
1. Go to Option Feeder Mode Error on page 2-451.
Troubleshooting Procedure
Step Actions and Questions
1. Remove the paper.