Xerox Phaser 7100 Service Manual

Error Troubleshooting
Phaser 7100 Service Manual Xerox Internal Use Only2-100
Under Non-transmitted Image log Stagnation
A limit to was imposed on creation of new jobs due to a backlog of untransferred image logs when the
System Data 'Assurance Level' is set as [High].
Applicable Fault Code
• 016-461: Under Non-transmitted Image Log Stagnation
Initial Actions
• Power cycle the printer.
• If the problem persists, perform the following procedure
.
Troubleshooting Procedure
Step Actions and Questions
1. Check the image log management server status and the network status, and clear any cause that
may impede the transfer of image logs to the image log server.
2. Check the transfer settings and transfer all logs that are yet to be transferred.
Or, change the transfer guarantee level to “Low”.
Note that setting the transfer guarantee level to “Low” may cause the image logs to get deleted in
sequence even before they are transferred.

Xerox Phaser 7100 Specifications

General

Maximum Print Resolution	1200 x 1200 dpi
Monthly Duty Cycle	Up to 52, 000 pages
Processor	667 MHz
Memory (Standard)	256 MB
Paper Input Capacity (Maximum)	2, 050 sheets
Paper Output Capacity	250 sheets
Duplex Printing	Automatic
Type	Color Laser Printer
Operating System Compatibility	Windows, Mac OS, Linux
Connectivity	USB 2.0, Ethernet
Supported Media Sizes	A4, A5, B5, Letter, Legal
First Page Out (Black)	9 seconds
First Page Out (Color)	9 seconds
Print Languages	PCL 6, PostScript 3
Network Connectivity	Ethernet
Print Speed	Up to 30 ppm