Service Parts Disassembly
Xerox Internal Use Only Phaser 7100 Service Manual 4-211
REP 12.7 LVPS PWB
PL 12.2.1
CAUTION: PWB’s can be damaged by an electrostatic discharge. Observe all ESD procedures to
avoid component damage.
1. Remove the I/P PWB Cover Assembly (REP 1.5 Image Processor (I/P) PWB Cover Assembly on
page 4-19).
2. Remove the Rear Cover (REP 1.6 Rear Cover on page 4-20).
3. Loosen 8 screws (silver, 6 mm) that secure the LVPS Shield Plate (PL 12.2.2).
4. Slide the LVPS Shield Plate upward and toward the rear of the printer to remove.
To Next Page
Loading...
