Service Parts Disassembly
Phaser 7100 Service Manual Xerox Internal Use Only4-144
REP 8.3 Waste Auger Assembly (Trickle Guide Assembly)
PL 8.1.10
CAUTION: Do not expose the Imaging Unit to light for more than 5 minutes. Cover the Imaging
Unit to avoid damage. Do not touch the surface of the Imaging Unit.
Note: For additional tips, refer to the Waste Auger Assembly Removal video (also available in the
Phaser 7100 Training materials).
1. Remove the Imaging Unit (Y/ M/ C/ K) (REP 6.0 Imaging Unit (Y/ M/ C/ K) on page 4-121).
2. Remove Tray 1.
3. Remove the I/P PWB Cover Assembly (REP 1.5 Image Processor (I/P) PWB Cover Assembly on
page 4-19).
4. Remove the Rear Cover (REP 1.6 Rear Cover on page 4-20).
5. Remove the Right Side Cover (REP 1.11 Right Side Cover on page 4-27).
6. Remove the Left Side Cover (REP 1.10 Left Side Cover on page 4-25).
7. Remove the Right Feeder Cover (REP 2.3 Right Feeder Cover on page 4-40).
8. Remove the Cam Cover (REP 9.7 Cam Cover on page 4-170).
9. Remove the IBT Retract Cam Assembly (REP 9.6 IBT Retract Cam Assembly on page 4-168).
10. Remove the Right Imaging Unit Guide Assembly (REP 6.1 Right Imaging Unit Guide Assembly on
page 4-123).
11. Remove the Left Imaging Unit Guide Assembly (REP 6.5 Left Imaging Unit Guide Assembly on
page 4-129).
12. Remove the Developer Housing Assembly (Y/ M/ C/ K) (REP 8.1 Developer Housing Assembly (Y/
M/ C/ K) on page 4-137).
13. Remove the Laser Unit (REP 7.1 ROS Assembly (Laser Unit)/ Front Spring Assembly/ Right Rear
Spring Assembly/ Left Rear Spring Assembly on page 4-130).
14. Remove the LVPS Fan Assembly (REP 12.16 LVPS Fan Assembly on page 4-226).
To Next Page
Loading...
Need help?
General