Xerox Phaser 7100

Error Troubleshooting
Phaser 7100 Service Manual Xerox Internal Use Only2-268
Option Registration On Jam
After the Tray 2 Paper Jam Sensor has detected a paper, the paper did not reach the Registration
Sensor.
Applicable Fault Code
• 077-117: Option Regi On Jam
Initial Actions
• Check the paper path for debris.
• If the problem persists, perform the following procedure.
Troubleshooting Reference
Applicable Parts Wiring and Plug/Jack Map References
• Turn Roller Assembly, PL 2.2.1
• Feed Roller Clutch, PL 2.2.8
• Nudger Roller/ Feed Roller, PL 2.2.11
• Retard Roller/ Feed Roller, PL 2.3.12
• Registration Sensor, PL 5.1.3
• Bypass Tray Turn Roller, PL 5.1.8
• Turn Roller Clutch, PL 5.1.9
• Paper Handling Motor (P/H Drive Assembly), PL 11.1.19
• MCU PWB, PL 12.1.15
• Paper Jam Sensor, PL 15.2.3
• Feeder PWB, PL 15.2.33
Troubleshooting Procedure
Step Actions and Questions
1. Refer to Tray 1 Miss Feed Jam/ Option Regi On Jam on page 2-246.