Xerox Phaser 7100

Plug/Jack and Wiring Diagrams
Phaser 7100 Service Manual Xerox Internal Use Only7-42
Exit Paper Sensed Signal The signal for detecting the paper output at the Fuser Unit by the
Fuser Unit Exit Sensor
(Paper detected: L)
STS Heat Roller surface temperature data measured by the Rear Temp
Sensor that is used for the detection of high temperatures (analog
value)
NC VD Heat Roller surface temperature data measured by the Center Temp
Sensor that is used for the temperature control (analog value)
NC VC
Fuser Unit Signal Lines (Continued)
Signal Line Name Description