General and Operation Overview
Phaser 7100 Service Manual Xerox Internal Use Only1-16
However, should you require simplex/ 1-sided printing, you may change the print settings in the print
driver.
Paper Types
This product can be used to print on both recycled and virgin paper, approved to an environmental
stewardship scheme, which complies with EN12281 or a similar quality standard. Lighter weight paper
(60 g/m²), which contains less raw material and thus save resources per print, may be used in certain
applications. We encourage you to check if this is suitable for your printing needs.
Power Consumption and Activation Time
The amount of electricity a product consumes depends on the way the device is used. This product is
designed and configured to enable you to reduce your electricity costs. After the last print, it switches
to Ready Mode. In this mode, it can print again immediately as needed. If the product is not used for a
period of time, the device switches to Energy Saver Mode. In this mode, only essential functions remain
active in order to enable reduced product power consumption.
Upon exiting from Energy Saver Mode, the first print takes slightly longer than in Ready Mode. This
delay is the result of the system leaving Energy Saver mode and is typical of most imaging products on
the market.
There is something to consider if you wish to set a longer Activation Time or would like to deactivate
the Energy Saver Mode completely. The device can switch to a lower energy level only after a longer
period of time or not at all.
To learn more about Xerox participation in sustainability initiatives, visit our web site at:
www.xerox.com/environment
To Next Page
Loading...
Need help?
General
