Error Troubleshooting
Phaser 7100 Service Manual Xerox Internal Use Only2-338
116-348/ 116-349/ 116-351
System error has occurred due to one of the following problems.
• A response such as system function recall error was detected.
• An error when calling the Pflite function at SIF.
• A problem has occurred in the software processing and it is unable to continue with the
subsequent processes.
Applicable Fault Codes
• 116-348: <Redirector Fail> Various fatal errors detected by the redirector.
• 116-349: An error occurred when calling the Pflite function using the SIF.
• 116-351: An EtherTalk-related fatal error.
Initial Actions
• Power cycle the printer.
• If the problem persists, perform the following procedure
.
Troubleshooting Procedure
Step Actions and Questions
1. Turn the printer power Off and On. Perform the same operation and check whether the problem is
reoccurring.
2. If the problem persists, go to Common System Fail on page 2-406.
If Common System Fail procedure is NG, go to Network Troubleshooting on page 2-459.
To Next Page
Loading...
