Xerox Phaser 7100 Service Manual

Image Quality
Phaser 7100 Service Manual Xerox Internal Use Only3-46
4. Check the Transfer Roller (2nd BTR) installation.
Is the Transfer Roller installed properly?
Go to step 6. Reinstall the Transfer
Roller (REP 4.10
Transfer Roller (2nd
BTR Unit) on
page 4-108).
5. Check the Transfer Roller (2nd BTR).
Is the Transfer Roller normal, without any
contamination, damage, or wear and tear?
Go to step 6. Replace the Transfer
Roller (REP 4.10
Transfer Roller (2nd
BTR Unit) on
page 4-108).
Reset the Transfer
Roller counter
(Resetting the Transfer
Roller (2nd BTR)
Counter on
page 6-12).
6. Check the IBT Unit.
Is the high voltage terminal of the IBT Unit free
from contamination and it is in proper contact
with the Spring?
Go to step 7. Clean the high
voltage terminal.
Reinstall the IBT Unit
(REP 9.10 IBT Unit on
page 4-177).
7. Check the Intermediate Transfer Belt.
Is the IBT Unit normal, without contamination,
damage, or wear and tear?
Go to step 8. Replace the IBT Unit
(REP 9.10 IBT Unit on
page 4-177).
8. Check the HVPS2 PWB connectors.
Are the connectors seated securely?
Replace the HVPS2
PWB (REP 12.1 HVPS2
PWB on page 4-202).
Reconnect the wiring
harness connectors.
Troubleshooting Procedure (Continued)
Step Actions and Questions Yes No

Xerox Phaser 7100 Specifications

General

Brand	Xerox
Model	Phaser 7100
Category	Printer
Language	English