Xerox Phaser 7100

Service Parts Disassembly
Xerox Internal Use Only Phaser 7100 Service Manual 4-77
19. Remove one screw (silver, 6 mm) that secures the Harness Holder (PL 11.1.21) to the Paper
Handling Drive Assembly (PL 11.1.19) and remove the Harness Holder.
20. Remove one screw (silver, 6 mm) that secures the Ground Wire to the Paper Handling Drive
Assembly and remove the Ground Wire.
21. Release the Main Switch Link Shaft (PL 13.1.14).
22. Disconnect the wiring harness connector P/J503 that is connected to the AC PWB (PL 12.1.16).
23. Release the wiring harness that is connected to the left of the Front Frame Assembly.
s7100-094
P/J503
Ground Wire