Service Parts Disassembly
Xerox Internal Use Only Phaser 7100 Service Manual 4-163
5. Turn the Waste Cartridge Assembly (PL 9.1.1) upward and pull it out from the left and right guide
to remove it.
6. Disconnect the wiring harness connector P/J4685 that is connected to the Waste Cartridge Guide
Assembly and release the wiring harness from the Harness Guide.
7. Remove 4 screws (silver, tapped, 8 mm) that secure the Waste Cartridge Guide Assembly.
8. Remove the Waste Cartridge Guide Assembly together with the Front Guide Plate.
Note: When removing the Waste Cartridge Guide Assembly in the next step, be careful not to spill
toner onto the Belt.
9. Pivot the Waste Cartridge Guide Assembly upward to release the tab underneath it to remove.
To Next Page
Loading...
