NETGEAR ProSAFE M7100-24X - Page 142

Switching Commands
142
ProSAFE M7100 Managed Switches
The following shows example CLI display output for the command.
(switch) #show lldp remote-device all
LLDP Remote Device Summary
Local
Interface RemID Chassis ID Port ID System Name
------- ------- -------------------- ------------------ ------------------
0/1
0/2
0/3
0/4
0/5
0/6
0/7 2 00:FC:E3:90:01:0F 00:FC:E3:90:01:11
0/7 3 00:FC:E3:90:01:0F 00:FC:E3:90:01:12
0/7 4 00:FC:E3:90:01:0F 00:FC:E3:90:01:13
0/7 5 00:FC:E3:90:01:0F 00:FC:E3:90:01:14
0/7 1 00:FC:E3:90:01:0F 00:FC:E3:90:03:11
0/7 6 00:FC:E3:90:01:0F 00:FC:E3:90:04:11
0/8
0/9
0/10
0/11
0/12
--More-- or (q)uit
show lldp remote-device detail
Use this command to display detailed information about remote devices that transmit current
LLDP data to an interface on the system.
Port ID The port number that transmitted the LLDPDU.
System Name The system name of the remote device.
Format show lldp remote-device detail <slot/port>
Mode Privileged EXEC
Term Definition
Local Interface The interface that received the LLDPDU from the remote device.
Remote Identifier An internal identifier to the switch to mark each remote device to the system.
Term Definition