NETGEAR ProSAFE M7100-24X - Page 600

Log Messages
600
ProSAFE M7100 Managed Switches
IPsubnet vlans vlanIpSubnetVlanChangeCallback: Failed to
add an Entry
Appears when a dtl fails to add an entry for a
VLAN add notify event.
IPsubnet vlans vlanIpSubnetVlanChangeCallback: Failed to
delet
e an Entry
Appears when a dtl fails to delete an entry for
a VLAN delete notify event.
Table 29. Mac-based VLANs Log Messages
Component Message Cause
Mac based VLANS MAC VLANs: Failed to save configuration This message appears when save
configur
ation of Mac VLANs failed
Mac based VLANS vlanMacCnfgrInitPhase1Process: Unable to
cre
ate r/w lock for vlanMac
Appears when a read/write lock creations
fails
Mac based VLANS Unable to register for VLAN change callback Appears when this component unable to
regis
ter for VLAN change notifications
Mac based VLANS vlanMacCnfgrFiniPhase1Process: could not
delet
e avl semaphore
Appears when a semaphore deletion of this
component fails.
Mac based VLANS vlanMacAddApply: Failed to add an entry Appears when a dtl call fails to add an entry
into the t
able
Mac based VLANS vlanMacDeleteApply: Unable to delete an
Entry
Appe
ars when a dtl fails to delete an entry
from the table
Mac based VLANS vlanMacVlanChangeCallback: Failed to add an
entry
Appe
ars when a dtl fails to add an entry for a
VLAN add notify event.
Mac based VLANS vlanMacVlanChangeCallback: Failed to delete
an entry
Appe
ars when a dtl fails to delete an entry for
a VLAN delete notify event.
Table 30. 802.1x Log Messages
Component Message Cause
802.1X function: Failed calling dot1xIssueCmd 802.1X message queue is full
802.1X function: EAP message not received from
serv
er
RADIUS server did not send required EAP
message
802.1X function: Out of System buffers 802.1X cannot process/transmit message
due to lack of int
ernal buffers
802.1X function: could not set state to
<authorized/
unauthorized>, intf xxx
DTL call failed setting authorization state of
the port
802.1X dot1xApplyConfigData: Unable to
<enable/disable> do
t1x in driver
DTL call failed enabling/disabling 802.1X
Table 28. IP Subnet VLANS Log Messages
Component Message Cause