Xerox Phaser 7100

Error Troubleshooting
Xerox Internal Use Only Phaser 7100 Service Manual 2-17
DC301 NVM Initialize •SysSystem
•Area:
- SysUser
- IOT
- Finisher
- SysSystem
Resets the NVM value to default value
of all applicable NVM within a specified
service or module.
Subsystem Check Adjusts/ corrects the printer operations of the IOT subsystem.
DC671 RegiMeasure No Function
DC673 Regi Check No Function
DC675 Regi Setup No Function
DC676 Adjust ROS • Press OK to run
• Completed
• Completed-Error
Corrects the ROS Lead Regi Parameter
when the ROS Assembly has been
replaced.
DC740 Adjust Guide No Function
Max Setup Displays adjustment items.
Note: The Max Setup adjustment items cannot be run.
DC924 Adjust TRC No Function
DC937 Pcon Print No Function
DC949 ATC Init Set No Function
DC950 ATC Setup No Function
DC991 Tone Up Down No Function
Service Diagnostics Routines
Test Control Panel Display Test Description