Error Troubleshooting
Xerox Internal Use Only Phaser 7100 Service Manual 2-51
8. Use Right Arrow to display the initialization area selection Area - SysUser screen.
Note: Use Down/ Up Arrow in the order of: Area - SysUser, Area - IOT, Area - Finisher, Area -
Account, and Area - SysSystem.
9. Press OK to confirm the area. When the item has been selected and confirmed, DC301 NVM Init. -
SysUser appears on the run instruction screen.
10. Press OK to initialize the confirmed area. After the operation, an “
*
” appears on the right side of
the display.
11. Use Right Arrow or Menu to display the NVM Initialized - Please exit Diag screen.
12. Press Menu to return to the Diagnostics - Adjustment menu screen.
To Next Page
Loading...
