Xerox Phaser 7100

Error Troubleshooting
Phaser 7100 Service Manual Xerox Internal Use Only2-66
027-723 Link to Application During Web Service Interface - Authentication Failure 2-223
027-724 Link to Application During Web Service Interface - Access Failure 2-224
027-725 Link to Application During Web Service Interface - Job Operation Failure 2-224
027-726 Link to Application During Web Service Interface - Unknown Job Status 2-224
027-727 Link to Application During Web Service - Invalid Parameter 2-225
027-751 Instruction Analysis Error 2-225
027-752 Mandatory User Not Entered 2-226
027-753 Invalid Instruction Service 2-226
027-754 File Signature Settings Mismatch in Instruction 2-227
027-761 Although a Web Print job was received, printing is unable to start within the
[On-Demand Print Duration] (the [On-Demand Print Duration] is a KO
system data)
2-228
027-762 Although a Web Print job was received, the attached job execution ticket is
incorrect.
2-229
027-763 Auditron - Cannot Verify User 2-229
041
041-310 IM Logic Fail 2-230
041-318 IOT Serial Number Fail 2-231
041-321 XPC Fail 2-231
041-322 IOT Data Fail 2-231
041-340 MCU NVM (EEPROM) Data Fail 2-232
041-400 300K Kit Change Soon -----
041-401 300K Kit Quality Life End 2-233
042
042-323 Drum K Motor Drive Fail 2-234
042-329 HVPS2 Fan Failure 2-236
042-335 Developer Fan (Process Fan 1) Failure 2-238
042-347 Drum YMC Motor Drive Fail 2-239
042-348 Over Temperature Detect -----
042-398 LVPS Fan Failure 2-241
042-610 Speed Limit Status Detected -----
Error Message and Chain Link Code Display (Continued)
Chain Link Control Panel Message Go to Page