Xerox Phaser 7100

Service Parts Disassembly
Xerox Internal Use Only Phaser 7100 Service Manual 4-139
13. Lift the Shaft (see Figure 3) on the right side of the Developer Housing Assembly (Y/ M/ C/ K) from
the groove, then slant the right side of the Developer Housing Assembly (Y/ M/ C/ K) to the front
while pulling it upwards.
Notes:
• When removing the Developer Housing Assembly (Y/ M/ C/ K) in the following step, be
careful when handling the Developer Housing Assembly to prevent from spilling the
toner from the Toner Dispenser.
• Be careful not to drop or lose the Spring that is attached to the Developer Housing
Assembly (Y/ M/ C/ K).
Figure 2
s7100-343