NETGEAR ProSAFE M7100-24X - Page 602

Log Messages
602
ProSAFE M7100 Managed Switches
GARP/GVRP/
GMRP
garpMapIntfIsConfigurable,
gmrpMapIntfIsConfigurable: Error accessing
GARP/GMRP config data for interface %d in
garpMapIntfIsConfigurable.
A default configuration does not exist for this
int
erface. Typically a case when a new
interface is created and has no
pre-configuration.
GARP/GVRP/
GMRP
garpTraceMsgQueueUsage: garpQueue
usage has e
x
ceeded fifty/eighty/ninety
percent
Traces the buildup of message queue. Helpful
in determining the load on GARP.
GARP/GVRP/
GMRP
gid_destroy_port: Error Removing port %d
r
egis
tration for vlan-mac %d -
%02X:%02X:%02X:%02X:%02X:%02X
Mismatch between the gmd (gmrp database)
and MFDB.
GARP/GVRP/
GMRP
gmd_create_entry: GMRP failure adding
MFDB entr
y
: vlan %d and address %s
MFDB table is full.
Table 33. 802.3ad Log Messages
Component Message Cause
802.3ad dot3adReceiveMachine: received default
event %x
R
eceived a LAG PDU and the RX state
machine is ignoring this LAGPDU
802.3ad dot3adNimEventCompletionCallback,
dot3adNimE
ventCreateCompletionCallback:
DOT3AD: notification failed for event(%d),
intf(%d), reason(%d)
The event sent to NIM was not completed
suc
cessfully
Table 34. FDB Log Message
Component Message Cause
FDB fdbSetAddressAgingTimeOut: Failure setting
fid %d addres
s aging timeout to %d
Unable to set the age time in the hardware
Table 35. Double VLAN Tag Log Message
Component Message Cause
Double Vlan Tag dvlantagIntfIsConfigurable: Error accessing
dvlantag c
onfig data for interface %d
A default configuration does not exist for this
interface. Typically a case when a new
interface is created and has no
pre-configuration.
Table 32. GARP/GVRP/GMRP Log Messages
Component Message Cause