NETGEAR ProSAFE M7100-24X - Page 603

Log Messages
603
ProSAFE M7100 Managed Switches
Table 36. IPv6 Provisioning Log Message
Component Message Cause
IPV6 Provisioning ipv6ProvIntfIsConfigurable: Error accessing
IPv6 Pr
ovisioning config data for interface
%d
A default configuration does not exist for this
interface. Typically a case when a new
interface is created and has no
pre-configuration.
Table 37. MFDB Log Message
Component Message Cause
MFDB mfdbTreeEntryUpdate: entry does not exist Trying to update a non-existing entry
Table 38. 802.1Q Log Messages
Component Message Cause
802.1Q dot1qIssueCmd: Unable to send message %d
to do
t1qMsgQueue for vlan %d - %d msgs in
queue
dot1qMsgQueue is full.
802.1Q dot1qVlanCreateProcess: Attempt to create
a vlan with an invalid vlan id %d ;
VL
AN %d not in range,
Accommodates for reserved vlan ids. that is,
4094 - x
802.1Q
dot1qMapIntfIsConfigurable: Error
accessing DOT1Q config data for
interface %d in
dot1qMapIntfIsConfigurable.
A default configuration does not exist for this
interface. Typically a case when a new
interface is created and has no
pre-configuration.
802.1Q dot1qVlanDeleteProcess: Deleting the
def
ault VL
AN
Typically encountered during clear Vlan and
clear config
802.1Q dot1qVlanMemberSetModify,
dot1qVlanT
aggedMemberSetModify:
Dynamic entry %d can only be modified after
it is converted to static
If this vlan is a learnt via GVRP then, we
c
annot modify its member set via
management.