Siemens SINAMICS DCM

To Next Page

To Previous Page

SINAMICS DCM

List Manual (LH8), 02/2015, 6RX1800-0ED76

161

2 Parameters

2.2 List of parameters

Description: Setting to invert the individual binector outputs of the connector-binector converter.

Using p2098[0], the signals of connector input p2099[0] are influenced.

Using p2098[1], the signals of connector input p2099[1] are influenced.

Dependency: Refer to: r2094, r2095, p2099

Description: Setting to invert the individual binector outputs of the connector-binector converter.

Using p2098[0], the signals of connector input p2099[0] are influenced.

Using p2098[1], the signals of connector input p2099[1] are influenced.

Dependency: Refer to: r2094, r2095, p2099

p2098[0...1] Inverter connector-binector converter binector output / Con/bin outp inv

CU_DC, CU_DC_R,

CU_DC_R_S,

CU_DC_S, DC_CTRL,

DC_CTRL_R,

DC_CTRL_R_S,

DC_CTRL_S

Can be changed: U, T Calculated: - Access level: 3

Data type: Unsigned16 Dyn. index: - Func. diagram: 2460, 2481

P-Group: Communications Unit group: - Unit selection: -

Not for motor type: - Scaling: - Expert list: 1

Min Max Factory setting

- - 0000 0000 0000 0000 bin

Bit field: Bit Signal name 1 signal 0 signal FP

00 Bit 0 Inverted Not inverted -

01 Bit 1 Inverted Not inverted -

02 Bit 2 Inverted Not inverted -

03 Bit 3 Inverted Not inverted -

04 Bit 4 Inverted Not inverted -

05 Bit 5 Inverted Not inverted -

06 Bit 6 Inverted Not inverted -

07 Bit 7 Inverted Not inverted -

08 Bit 8 Inverted Not inverted -

09 Bit 9 Inverted Not inverted -

10 Bit 10 Inverted Not inverted -

11 Bit 11 Inverted Not inverted -

12 Bit 12 Inverted Not inverted -

13 Bit 13 Inverted Not inverted -

14 Bit 14 Inverted Not inverted -

15 Bit 15 Inverted Not inverted -