2 Parameters
2.2 List of parameters
SINAMICS DCM
434 List Manual (LH8), 02/2015, 6RX1800-0ED76
Description: Sets the smoothing time constant for the EMF controller's setpoint.
Dependency: Refer to: p50282
Note: This smoothing enables the EMF controller pre-control to be decoupled from the EMF controller.
Description: Sets the smoothing time constant for the EMF controller's actual value.
Dependency: Refer to: p50281
Note: This smoothing enables the EMF controller pre-control to be decoupled from the EMF controller.
Description: Sets the smoothing time constant for the actual value for EMF controller pre-control.
Dependency: Refer to: p50280
Note: This smoothing enables the EMF controller pre-control to be decoupled from the EMF controller.
Description: Sets activation/de-activation of the proportional component on the EMF controller.
Value: 0: Deactivated
1: Activated
Dependency: Refer to: p50275, p50276
Note: If value = 0:
The proportional component of the EMF controller is kept constantly at zero (i.e. the EMF controller functions solely
as an integral controller).
p50281[0...n] EMF controller setpoint smoothing time constant / EMF ctr set T
DC_CTRL Can be changed: U, T Calculated: - Access level: 2
Data type: FloatingPoint32 Dyn. index: DDS, p0180 Func. diagram: 6900
P-Group: - Unit group: - Unit selection: -
Not for motor type: - Scaling: - Expert list: 1
Min Max Factory setting
0 [ms] 10000 [ms] 0 [ms]
p50282[0...n] EMF controller actual value smoothing time constant / EMF ctr act T
DC_CTRL Can be changed: U, T Calculated: - Access level: 2
Data type: FloatingPoint32 Dyn. index: DDS, p0180 Func. diagram: 6900
P-Group: - Unit group: - Unit selection: -
Not for motor type: - Scaling: - Expert list: 1
Min Max Factory setting
0 [ms] 10000 [ms] 0 [ms]
p50283[0...n] EMF controller pre-control actual value smoothing time constant / EMF prec act T
DC_CTRL Can be changed: U, T Calculated: - Access level: 2
Data type: FloatingPoint32 Dyn. index: DDS, p0180 Func. diagram: 6900
P-Group: - Unit group: - Unit selection: -
Not for motor type: - Scaling: - Expert list: 1
Min Max Factory setting
0 [ms] 10000 [ms] 0 [ms]
p50284[0...n] EMF controller proportional component activation / EMF ctr P comp act
DC_CTRL Can be changed: T Calculated: - Access level: 2
Data type: Integer16 Dyn. index: DDS, p0180 Func. diagram: 6900
P-Group: - Unit group: - Unit selection: -
Not for motor type: - Scaling: - Expert list: 1
Min Max Factory setting
0 1 1
To Next Page
Loading...
