2 Parameters
2.2 List of parameters
SINAMICS DCM
456 List Manual (LH8), 02/2015, 6RX1800-0ED76
Description: Sets the signal level for fixed bit 0.
Value: 0: Low
1: High
Dependency: Refer to: r53230
Note: This signal can be interconnected via binector output r53230.0.
Description: Sets the signal level for fixed bit 1.
Value: 0: Low
1: High
Dependency: Refer to: r53230
Note: This signal can be interconnected via binector output r53230.1.
Description: Sets the signal level for fixed bit 2.
Value: 0: Low
1: High
Dependency: Refer to: r53230
Note: This signal can be interconnected via binector output r53230.2.
Description: Sets the signal level for fixed bit 3.
Value: 0: Low
1: High
Dependency: Refer to: r53230
Note: This signal can be interconnected via binector output r53230.3.
p50421[0...n] Fixed bit 0 / Fixed bit 0
DC_CTRL Can be changed: U, T Calculated: - Access level: 2
Data type: Integer16 Dyn. index: DDS, p0180 Func. diagram: 3100
P-Group: - Unit group: - Unit selection: -
Not for motor type: - Scaling: - Expert list: 1
Min Max Factory setting
0 1 0
p50422[0...n] Fixed bit 1 / Fixed bit 1
DC_CTRL Can be changed: U, T Calculated: - Access level: 2
Data type: Integer16 Dyn. index: DDS, p0180 Func. diagram: 3100
P-Group: - Unit group: - Unit selection: -
Not for motor type: - Scaling: - Expert list: 1
Min Max Factory setting
0 1 0
p50423[0...n] Fixed bit 2 / Fixed bit 2
DC_CTRL Can be changed: U, T Calculated: - Access level: 2
Data type: Integer16 Dyn. index: DDS, p0180 Func. diagram: 3100
P-Group: - Unit group: - Unit selection: -
Not for motor type: - Scaling: - Expert list: 1
Min Max Factory setting
0 1 0
p50424[0...n] Fixed bit 3 / Fixed bit 3
DC_CTRL Can be changed: U, T Calculated: - Access level: 2
Data type: Integer16 Dyn. index: DDS, p0180 Func. diagram: 3100
P-Group: - Unit group: - Unit selection: -
Not for motor type: - Scaling: - Expert list: 1
Min Max Factory setting
0 1 0
To Next Page
Loading...
