Siemens SINAMICS DCM - Non Safety-Relevant Measuring Steps Position Value Pos1; Nsrpos1; Redundant Coarse Position Value Fine Resolution Bits; Fine Bit; Redundant Coarse Position Value Relevant Bits; Relevant Bits; Redundant Coarse Position Value Valid Bits; Valid Bits

SINAMICS DCM
List Manual (LH8), 02/2015, 6RX1800-0ED76
85
2 Parameters
2.2 List of parameters
Description: Displays the valid bits of the redundant coarse position value.
Index: [0] = Encoder 1
[1] = Encoder 2
[2] = -
Description: Displays the number of valid bits for the fine resolution of the redundant coarse position value.
Index: [0] = Encoder 1
[1] = Encoder 2
[2] = -
Description: Displays the number of relevant bits for the redundant coarse position value.
Index: [0] = Encoder 1
[1] = Encoder 2
[2] = -
Description: Displays the non safety-relevant measuring steps of POS1.
Index: [0] = Encoder 1
[1] = Encoder 2
[2] = Encoder 3
Dependency: Refer to: p0416
r0470[0...2] Redundant coarse position value valid bits / Valid bits
DC_CTRL,
DC_CTRL_R,
DC_CTRL_R_S,
DC_CTRL_S
Can be changed: - Calculated: - Access level: 3
Data type: Unsigned16 Dyn. index: - Func. diagram: -
P-Group: Encoder Unit group: - Unit selection: -
Not for motor type: - Scaling: - Expert list: 1
Min Max Factory setting
- - -
r0471[0...2] Redundant coarse position value fine resolution bits / Fine bit
DC_CTRL,
DC_CTRL_R,
DC_CTRL_R_S,
DC_CTRL_S
Can be changed: - Calculated: - Access level: 3
Data type: Integer16 Dyn. index: - Func. diagram: -
P-Group: Encoder Unit group: - Unit selection: -
Not for motor type: - Scaling: - Expert list: 1
Min Max Factory setting
- - -
r0472[0...2] Redundant coarse position value relevant bits / Relevant bits
DC_CTRL,
DC_CTRL_R,
DC_CTRL_R_S,
DC_CTRL_S
Can be changed: - Calculated: - Access level: 3
Data type: Unsigned16 Dyn. index: - Func. diagram: -
P-Group: Encoder Unit group: - Unit selection: -
Not for motor type: - Scaling: - Expert list: 1
Min Max Factory setting
- - -
r0473[0...2] Non safety-relevant measuring steps position value pos1 / nsrPos1
DC_CTRL,
DC_CTRL_R,
DC_CTRL_R_S,
DC_CTRL_S
Can be changed: - Calculated: - Access level: 3
Data type: Unsigned32 Dyn. index: - Func. diagram: -
P-Group: Encoder Unit group: - Unit selection: -
Not for motor type: - Scaling: - Expert list: 1
Min Max Factory setting
- - -