Siemens SINAMICS DCM - BO: IF2 PZD1 Receive Bit-Serial; IF2 PZD1 Recv Bitw; CO: IF2 Send Binector-Connector Converter Status Word

To Next Page

To Previous Page

2 Parameters

2.2 List of parameters

SINAMICS DCM

340 List Manual (LH8), 02/2015, 6RX1800-0ED76

Dependency: Refer to: p8880, p8881, p8882, p8883, p8884, r8889

Description: Connector output to interconnect the status words to a PZD send word.

Index: [0] = Status word 1

[1] = Status word 2

[2] = Free status word 3

[3] = Free status word 4

[4] = Free status word 5

Dependency: Refer to: p8851, p8880, p8881, p8882, p8883, p8884, p8888

Note: r8889 together with p8880 to p8884 forms five binector-connector converters.

Description: Binector output for bit-serial interconnection of PZD1 (normally control word 1) received via interface 2.

14 Bit 14 Inverted Not inverted -

15 Bit 15 Inverted Not inverted -

r8889[0...4] CO: IF2 send binector-connector converter status word / Bin/con ZSW send

DC_CTRL,

DC_CTRL_R,

DC_CTRL_R_S,

DC_CTRL_S

Can be changed: - Calculated: - Access level: 3

Data type: Unsigned16 Dyn. index: - Func. diagram: -

P-Group: Communications Unit group: - Unit selection: -

Not for motor type: - Scaling: - Expert list: 1

Min Max Factory setting

- - -

Bit field: Bit Signal name 1 signal 0 signal FP

00 Bit 0 ON OFF -

01 Bit 1 ON OFF -

02 Bit 2 ON OFF -

03 Bit 3 ON OFF -

04 Bit 4 ON OFF -

05 Bit 5 ON OFF -

06 Bit 6 ON OFF -

07 Bit 7 ON OFF -

08 Bit 8 ON OFF -

09 Bit 9 ON OFF -

10 Bit 10 ON OFF -

11 Bit 11 ON OFF -

12 Bit 12 ON OFF -

13 Bit 13 ON OFF -

14 Bit 14 ON OFF -

15 Bit 15 ON OFF -

r8890.0...15 BO: IF2 PZD1 receive bit-serial / IF2 PZD1 recv bitw