2 Parameters
2.2 List of parameters
SINAMICS DCM
452 List Manual (LH8), 02/2015, 6RX1800-0ED76
Description: Sets fixed value 1.
Dependency: Refer to: r52401
Note: This value can be interconnected via connector output r52401.
Description: Sets fixed value 2.
Dependency: Refer to: r52402
Note: This value can be interconnected via connector output r52402.
Description: Sets fixed value 3.
Dependency: Refer to: r52403
Note: This value can be interconnected via connector output r52403.
Description: Sets fixed value 4.
Dependency: Refer to: r52404
Note: This value can be interconnected via connector output r52404.
p50401[0...n] Fixed value 1 / Fix val 1
DC_CTRL Can be changed: U, T Calculated: - Access level: 2
Data type: FloatingPoint32 Dyn. index: DDS, p0180 Func. diagram: 3100
P-Group: - Unit group: - Unit selection: -
Not for motor type: - Scaling: PERCENT Expert list: 1
Min Max Factory setting
-200.00 [%] 200.00 [%] 0.00 [%]
p50402[0...n] Fixed value 2 / Fix val 2
DC_CTRL Can be changed: U, T Calculated: - Access level: 2
Data type: FloatingPoint32 Dyn. index: DDS, p0180 Func. diagram: 3100
P-Group: - Unit group: - Unit selection: -
Not for motor type: - Scaling: PERCENT Expert list: 1
Min Max Factory setting
-200.00 [%] 200.00 [%] 0.00 [%]
p50403[0...n] Fixed value 3 / Fix val 3
DC_CTRL Can be changed: U, T Calculated: - Access level: 2
Data type: FloatingPoint32 Dyn. index: DDS, p0180 Func. diagram: 3100
P-Group: - Unit group: - Unit selection: -
Not for motor type: - Scaling: PERCENT Expert list: 1
Min Max Factory setting
-200.00 [%] 200.00 [%] 0.00 [%]
p50404[0...n] Fixed value 4 / Fix val 4
DC_CTRL Can be changed: U, T Calculated: - Access level: 2
Data type: FloatingPoint32 Dyn. index: DDS, p0180 Func. diagram: 3100
P-Group: - Unit group: - Unit selection: -
Not for motor type: - Scaling: PERCENT Expert list: 1
Min Max Factory setting
-200.00 [%] 200.00 [%] 0.00 [%]
To Next Page
Loading...
Need help?
General
