Siemens SINAMICS DCM - CO;BO: Current Limitation State; Ia Lim State; CO;BO: Setpoint Processing Control Word; Set Proc STW; CO;BO: Speed Controller Enable; N_Ctr Ena; CO;BO: Speed Limiting Controller;Torque Limiting State

2 Parameters
2.2 List of parameters
SINAMICS DCM
638 List Manual (LH8), 02/2015, 6RX1800-0ED76
Description: Displays the state on the speed limiting controller and with regard to torque limiting.
Description: Display and connector output for the state of armature current limitation.
Description: Display and BICO output to enable the speed controller.
Description: Control word for setpoint processing.
r53150.0...5 CO/BO: Speed limiting controller/torque limiting state / n_lim/T lim state
DC_CTRL Can be changed: - Calculated: - Access level: 2
Data type: Unsigned16 Dyn. index: - Func. diagram: 6830, 6835
P-Group: - Unit group: - Unit selection: -
Not for motor type: - Scaling: - Expert list: 1
Min Max Factory setting
- - -
Bit field: Bit Signal name 1 signal 0 signal FP
00 Positive speed limit reached Yes No 6835
01 Negative speed limit reached Yes No 6835
02 Limiting controller active Yes No 6835
03 Positive torque limit reached Yes No 6830
04 Negative torque limit reached Yes No 6830
05 Torque limiting active Yes No 6830
r53151.0...4 CO/BO: Current limitation state / Ia lim state
DC_CTRL Can be changed: - Calculated: - Access level: 2
Data type: Unsigned16 Dyn. index: - Func. diagram: 6845
P-Group: - Unit group: - Unit selection: -
Not for motor type: - Scaling: - Expert list: 1
Min Max Factory setting
- - -
Bit field: Bit Signal name 1 signal 0 signal FP
00 Positive armature current limit reached Yes No 6845
01 Negative armature current limit reached Yes No 6845
02 Armature current limitation active Yes No 6845
04 Torque limiting/Armature current limitation
active
Yes No 6845
r53160.0 CO/BO: Speed controller enable / n_ctr ena
DC_CTRL Can be changed: - Calculated: - Access level: 2
Data type: Unsigned16 Dyn. index: - Func. diagram: 6815
P-Group: - Unit group: - Unit selection: -
Not for motor type: - Scaling: - Expert list: 1
Min Max Factory setting
- - -
Bit field: Bit Signal name 1 signal 0 signal FP
00 Speed controller enable present Yes No 6815
r53170.4...15 CO/BO: Setpoint processing control word / Set proc STW
DC_CTRL Can be changed: - Calculated: - Access level: 2
Data type: Unsigned16 Dyn. index: - Func. diagram: 2585
P-Group: - Unit group: - Unit selection: -
Not for motor type: - Scaling: - Expert list: 1
Min Max Factory setting
- - -