SINAMICS DCM
List Manual (LH8), 02/2015, 6RX1800-0ED76
623
2 Parameters
2.2 List of parameters
Description: Display and connector output of output 1 during the optimization run.
Description: Display and connector output of output 2 during the optimization run.
Description: Display and connector output of output 3 during the optimization run.
Description: Display and connector output of output 4 during the optimization run.
Description: Display and connector output for the raw values from the measurements of Power Stack ASIC 1.
For devices with 480 V:
- 0 corresponds to -825.0 V
- 32767 corresponds to 0 V
- 65535 corresponds to +825.0 V
r52901 CO: Optimization run output 1 / Opt run outp 1
DC_CTRL Can be changed: - Calculated: - Access level: 2
Data type: FloatingPoint32 Dyn. index: - Func. diagram: 2660
P-Group: - Unit group: - Unit selection: -
Not for motor type: - Scaling: PERCENT Expert list: 1
Min Max Factory setting
- [%] - [%] - [%]
r52902 CO: Optimization run output 2 / Opt run outp 2
DC_CTRL Can be changed: - Calculated: - Access level: 2
Data type: FloatingPoint32 Dyn. index: - Func. diagram: 2660
P-Group: - Unit group: - Unit selection: -
Not for motor type: - Scaling: PERCENT Expert list: 1
Min Max Factory setting
- [%] - [%] - [%]
r52903 CO: Optimization run output 3 / Opt run outp 3
DC_CTRL Can be changed: - Calculated: - Access level: 2
Data type: FloatingPoint32 Dyn. index: - Func. diagram: 2660
P-Group: - Unit group: - Unit selection: -
Not for motor type: - Scaling: PERCENT Expert list: 1
Min Max Factory setting
- [%] - [%] - [%]
r52904 CO: Optimization run output 4 / Opt run outp 4
DC_CTRL Can be changed: - Calculated: - Access level: 2
Data type: FloatingPoint32 Dyn. index: - Func. diagram: 2660
P-Group: - Unit group: - Unit selection: -
Not for motor type: - Scaling: PERCENT Expert list: 1
Min Max Factory setting
- [%] - [%] - [%]
r52921[0...4] CO: Measurement results ASIC 1 raw values / Meas res ASIC1 raw
DC_CTRL Can be changed: - Calculated: - Access level: 4
Data type: Unsigned16 Dyn. index: - Func. diagram: 8054
P-Group: - Unit group: - Unit selection: -
Not for motor type: - Scaling: - Expert list: 1
Min Max Factory setting
- - -
To Next Page
Loading...
