EasyManua.ls Logo

Siemens SINAMICS DCM - CO;BO: Line State; Line State; CO;BO: Thyristor State; Thyr State

Siemens SINAMICS DCM
1204 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
2 Parameters
2.2 List of parameters
SINAMICS DCM
636 List Manual (LH8), 02/2015, 6RX1800-0ED76
Dependency: Refer to: p51832, p51833, p51834, p51835
Refer to: A60266, F60267
Description: Displays the state of the line for armature and field.
Description: Display and connector output for the state of the thyristors.
Bit field: Bit Signal name 1 signal 0 signal FP
00 Fan ON ON OFF -
01 Fan ON inverted ON OFF -
02 Fan relay status Switched on Switched off -
03 External fault Yes No -
04 External fault inverted Yes No -
r53145.0...13 CO/BO: Line state / Line state
DC_CTRL Can be changed: - Calculated: - Access level: 2
Data type: Unsigned16 Dyn. index: - Func. diagram: 6950, 6954
P-Group: - Unit group: - Unit selection: -
Not for motor type: - Scaling: - Expert list: 1
Min Max Factory setting
- - -
Bit field: Bit Signal name 1 signal 0 signal FP
00 Armature supply system overvoltage Yes No -
01 Armature supply system undervoltage Yes No -
02 Armature supply system overfrequency Yes No -
03 Armature supply system underfrequency Yes No -
04 Armature supply system phase failure Yes No -
05 Field supply system overvoltage Yes No -
06 Field supply system undervoltage Yes No -
07 Field supply system overfrequency Yes No -
08 Field supply system underfrequency Yes No -
09 Field supply system phase failure Yes No -
10 Armature supply system OK Yes No -
11 Field supply system OK Yes No -
12 Phase rotating clockwise Yes No -
13 Line symmetry Yes No -
r53146.0...13 CO/BO: Thyristor state / Thyr state
DC_CTRL Can be changed: - Calculated: - Access level: 3
Data type: Unsigned16 Dyn. index: - Func. diagram: 6950
P-Group: - Unit group: - Unit selection: -
Not for motor type: - Scaling: - Expert list: 1
Min Max Factory setting
- - -
Bit field: Bit Signal name 1 signal 0 signal FP
00 Thyristor X11 conducting Yes No -
01 Thyristor X12 conducting Yes No -
02 Thyristor X13 conducting Yes No -
03 Thyristor X14 conducting Yes No -
04 Thyristor X15 conducting Yes No -
05 Thyristor X16 conducting Yes No -
08 Thyristor X21 conducting Yes No -
09 Thyristor X22 conducting Yes No -
10 Thyristor X23 conducting Yes No -
11 Thyristor X24 conducting Yes No -
12 Thyristor X25 conducting Yes No -
13 Thyristor X26 conducting Yes No -

Table of Contents

Other manuals for Siemens SINAMICS DCM

Related product manuals