Siemens SINAMICS DCM - CO: CUD Analog Input Main Actual Value; CUD AI M Act; CO: CUD Analog Input Main Actual Value Raw Value; CO: CUD Analog Input Main Setpoint; CUD AI M Set; CO: CUD Analog Input Main Setpoint Raw Value

SINAMICS DCM
List Manual (LH8), 02/2015, 6RX1800-0ED76
561
2 Parameters
2.2 List of parameters
Description: Display and connector output for the raw value at the "Main setpoint" analog input (X177.25/26).
Description: Display and connector output for the "Main setpoint" analog input (X177.25/26).
Description: Display and connector output for the raw value at the "Main actual value" analog input (XT1.103/104).
Description: Display and connector output for the "Main actual value" analog input (XT1.103/104).
Description: Display and connector output for the raw value at the analog "Select input 1" (X177.27/28).
r52010 CO: CUD analog input main setpoint raw value / CUD AI m set raw
DC_CTRL Can be changed: - Calculated: - Access level: 2
Data type: FloatingPoint32 Dyn. index: - Func. diagram: 2075
P-Group: - Unit group: - Unit selection: -
Not for motor type: - Scaling: PERCENT Expert list: 1
Min Max Factory setting
- [%] - [%] - [%]
r52011 CO: CUD analog input main setpoint / CUD AI m set
DC_CTRL Can be changed: - Calculated: - Access level: 1
Data type: FloatingPoint32 Dyn. index: - Func. diagram: 2075
P-Group: - Unit group: - Unit selection: -
Not for motor type: - Scaling: PERCENT Expert list: 1
Min Max Factory setting
- [%] - [%] - [%]
r52012 CO: CUD analog input main actual value raw value / CUD AI m act raw
DC_CTRL Can be changed: - Calculated: - Access level: 2
Data type: FloatingPoint32 Dyn. index: - Func. diagram: 2075
P-Group: - Unit group: - Unit selection: -
Not for motor type: - Scaling: PERCENT Expert list: 1
Min Max Factory setting
- [%] - [%] - [%]
r52013 CO: CUD analog input main actual value / CUD AI m act
DC_CTRL Can be changed: - Calculated: - Access level: 2
Data type: FloatingPoint32 Dyn. index: - Func. diagram: 2075, 6810
P-Group: - Unit group: - Unit selection: -
Not for motor type: - Scaling: PERCENT Expert list: 1
Min Max Factory setting
- [%] - [%] - [%]
r52014 CO: CUD analog input select input 1 raw value / CUD AI sel 1 raw
DC_CTRL Can be changed: - Calculated: - Access level: 2
Data type: FloatingPoint32 Dyn. index: - Func. diagram: 2080
P-Group: - Unit group: - Unit selection: -
Not for motor type: - Scaling: PERCENT Expert list: 1
Min Max Factory setting
- [%] - [%] - [%]