SINAMICS DCM
List Manual (LH8), 02/2015, 6RX1800-0ED76
599
2 Parameters
2.2 List of parameters
Description: Connector output for fixed value 9 set in p50409.
Dependency: Refer to: p50409
Description: Connector output for fixed value 10 set in p50410.
Dependency: Refer to: p50410
Description: Connector output for fixed value 11 set in p50411.
Dependency: Refer to: p50411
Description: Connector output for fixed value 12 set in p50412.
Dependency: Refer to: p50412
Description: Connector output for fixed value 13 set in p50413.
Dependency: Refer to: p50413
r52409 CO: Fixed value 9 / Fix val 9
DC_CTRL Can be changed: - Calculated: - Access level: 2
Data type: FloatingPoint32 Dyn. index: - Func. diagram: 3100
P-Group: - Unit group: - Unit selection: -
Not for motor type: - Scaling: PERCENT Expert list: 1
Min Max Factory setting
- [%] - [%] - [%]
r52410 CO: Fixed value 10 / Fix val 10
DC_CTRL Can be changed: - Calculated: - Access level: 2
Data type: FloatingPoint32 Dyn. index: - Func. diagram: 3100
P-Group: - Unit group: - Unit selection: -
Not for motor type: - Scaling: PERCENT Expert list: 1
Min Max Factory setting
- [%] - [%] - [%]
r52411 CO: Fixed value 11 / Fix val 11
DC_CTRL Can be changed: - Calculated: - Access level: 2
Data type: FloatingPoint32 Dyn. index: - Func. diagram: 3100
P-Group: - Unit group: - Unit selection: -
Not for motor type: - Scaling: PERCENT Expert list: 1
Min Max Factory setting
- [%] - [%] - [%]
r52412 CO: Fixed value 12 / Fix val 12
DC_CTRL Can be changed: - Calculated: - Access level: 2
Data type: FloatingPoint32 Dyn. index: - Func. diagram: 3100
P-Group: - Unit group: - Unit selection: -
Not for motor type: - Scaling: PERCENT Expert list: 1
Min Max Factory setting
- [%] - [%] - [%]
r52413 CO: Fixed value 13 / Fix val 13
DC_CTRL Can be changed: - Calculated: - Access level: 2
Data type: FloatingPoint32 Dyn. index: - Func. diagram: 3100
P-Group: - Unit group: - Unit selection: -
Not for motor type: - Scaling: PERCENT Expert list: 1
Min Max Factory setting
- [%] - [%] - [%]
To Next Page
Loading...
