EasyManuals Logo

Siemens SINAMICS DCM List Manual

Siemens SINAMICS DCM
1204 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #521 background imageLoading...
Page #521 background image
SINAMICS DCM
List Manual (LH8), 02/2015, 6RX1800-0ED76
521
2 Parameters
2.2 List of parameters
Description: Displays the transmit data for the peer-to-peer interface (P2P IF).
The signal source for the data to be transmitted is set via connector input p50794[0 to 4].
Index: [0] = Word 1
[1] = Word 2
[2] = Word 3
[3] = Word 4
[4] = Word 5
Dependency: Refer to: p50794
Description: Sets the signal source to enable data to be received on the peer-to-peer interface (P2P IF).
1 signal: Data receive enabled
0 signal: Data receive not enabled
Description: Sets the signal source to enable data to be transmitted on the peer-to-peer interface (P2P IF).
1 signal: Data transmission enabled
0 signal: Data transmission not enabled
Description: Sets the bus terminator for the RS485 interface (PPI/USS, X178).
Value: 0: OFF
1: ON
r50813[0...4] P2P IF transmit data display / P2P tr data disp
DC_CTRL Can be changed: - Calculated: - Access level: 1
Data type: Unsigned16 Dyn. index: - Func. diagram: 9300
P-Group: - Unit group: - Unit selection: -
Not for motor type: - Scaling: - Expert list: 1
Min Max Factory setting
- - -
p50816 BI: P2P IF receive enable signal source / P2P recv ena sig s
DC_CTRL Can be changed: T Calculated: - Access level: 2
Data type: Unsigned32 / Binary Dyn. index: - Func. diagram: 9300
P-Group: - Unit group: - Unit selection: -
Not for motor type: - Scaling: - Expert list: 1
Min Max Factory setting
- - 1
p50817 BI: P2P IF transmit enable signal source / P2P tr ena sig s
DC_CTRL Can be changed: T Calculated: - Access level: 2
Data type: Unsigned32 / Binary Dyn. index: - Func. diagram: 9300
P-Group: - Unit group: - Unit selection: -
Not for motor type: - Scaling: - Expert list: 1
Min Max Factory setting
- - 1
p50820 PPI/USS bus terminator / PPI/USS bus term
DC_CTRL Can be changed: U, T Calculated: - Access level: 1
Data type: Integer16 Dyn. index: - Func. diagram: 2410
P-Group: - Unit group: - Unit selection: -
Not for motor type: - Scaling: - Expert list: 1
Min Max Factory setting
0 1 1

Table of Contents

Other manuals for Siemens SINAMICS DCM

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Siemens SINAMICS DCM and is the answer not in the manual?

Siemens SINAMICS DCM Specifications

General IconGeneral
BrandSiemens
ModelSINAMICS DCM
CategoryMedia Converter
LanguageEnglish

Related product manuals