2 Parameters
2.2 List of parameters
SINAMICS DCM
304 List Manual (LH8), 02/2015, 6RX1800-0ED76
Description: Displays the version of the firmware stored on the device memory.
Index: [0] = Internal
[1] = External
[2] = Parameter backup
Note: Re index 0:
Displays the internal firmware version (e.g. 01402315).
This firmware version is the version of the device memory and not the CU firmware (r0018), however, normally they
have the same versions.
Re index 1:
Displays the external firmware version (e.g. 01040000 -> 1.4).
Re index 2:
Displays the internal CU firmware version (r0018) of the parameter backup.
With this CU firmware version, the parameter backup was saved, which was used when powering up.
Description: Displays whether, for an activated drive object, all activated topology components are available or not (or whether
these can be addressed).
0: Drive object not ready for operation
1: Drive object ready for operation
Description: Displays the number of indices for r7853[0...n].
This corresponds to the number of DRIVE-CLiQ components that are in the target topology.
Dependency: Refer to: r7853
Note: The values are valid if all available Control Units adopt the "Initialization finished" state (r3988 = 800) following
power-up.
r7844[0...2] Device memory firmware version / Dev_mem FW
CU_DC, CU_DC_R,
CU_DC_R_S,
CU_DC_S
Can be changed: - Calculated: - Access level: 1
Data type: Unsigned32 Dyn. index: - Func. diagram: -
P-Group: - Unit group: - Unit selection: -
Not for motor type: - Scaling: - Expert list: 1
Min Max Factory setting
- - -
r7850[0...n] Drive object operational/not operational / DO ready for oper
CU_DC, CU_DC_R,
CU_DC_R_S,
CU_DC_S
Can be changed: - Calculated: - Access level: 4
Data type: Integer16 Dyn. index: - Func. diagram: -
P-Group: - Unit group: - Unit selection: -
Not for motor type: - Scaling: - Expert list: 1
Min Max Factory setting
-32786 32767 -
p7852 Number of indices for r7853 / Qty indices r7853
CU_DC, CU_DC_R,
CU_DC_R_S,
CU_DC_S
Can be changed: U, T Calculated: - Access level: 4
Data type: Unsigned16 Dyn. index: - Func. diagram: -
P-Group: - Unit group: - Unit selection: -
Not for motor type: - Scaling: - Expert list: 1
Min Max Factory setting
1 200 1
To Next Page
Loading...
Need help?
General
