EasyManuals Logo

Siemens SINAMICS DCM List Manual

Siemens SINAMICS DCM
1204 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #622 background imageLoading...
Page #622 background image
2 Parameters
2.2 List of parameters
SINAMICS DCM
622 List Manual (LH8), 02/2015, 6RX1800-0ED76
Description: Display and binector/connector output for receive word 1 from slave 16 on the parallel interface.
Dependency: Refer to: r52716
Note: Receive word 1 is also available scaled word by word for further interconnection.
Description: Display and connector output for the sequence control operating state.
Note: The values correspond to the operating state of the drive (r0002 (DC_CTRL)).
Description: Display and connector output of output 0 during the optimization run.
r52736.0...15 CO/BO: Parallel interface slave 16 receive word 1 bit by bit / Slave16 recv1 bbb
DC_CTRL Can be changed: - Calculated: - Access level: 2
Data type: Unsigned16 Dyn. index: - Func. diagram: 9352
P-Group: - Unit group: - Unit selection: -
Not for motor type: - Scaling: - Expert list: 1
Min Max Factory setting
- - -
Bit field: Bit Signal name 1 signal 0 signal FP
00 Bit 0 Yes No 9352
01 Bit 1 Yes No 9352
02 Bit 2 Yes No 9352
03 Bit 3 Yes No 9352
04 Bit 4 Yes No 9352
05 Bit 5 Yes No 9352
06 Bit 6 Yes No 9352
07 Bit 7 Yes No 9352
08 Bit 8 Yes No 9352
09 Bit 9 Yes No 9352
10 Bit 10 Yes No 9352
11 Bit 11 Yes No 9352
12 Bit 12 Yes No 9352
13 Bit 13 Yes No 9352
14 Bit 14 Yes No 9352
15 Bit 15 Yes No 9352
r52800 CO: Sequence control operating state / S ctr op state
DC_CTRL Can be changed: - Calculated: - Access level: 2
Data type: Unsigned16 Dyn. index: - Func. diagram: 2651
P-Group: - Unit group: - Unit selection: -
Not for motor type: - Scaling: - Expert list: 1
Min Max Factory setting
- - -
r52900 CO: Optimization run output 0 / Opt run outp 0
DC_CTRL Can be changed: - Calculated: - Access level: 2
Data type: FloatingPoint32 Dyn. index: - Func. diagram: 2660
P-Group: - Unit group: - Unit selection: -
Not for motor type: - Scaling: PERCENT Expert list: 1
Min Max Factory setting
- [%] - [%] - [%]

Table of Contents

Other manuals for Siemens SINAMICS DCM

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Siemens SINAMICS DCM and is the answer not in the manual?

Siemens SINAMICS DCM Specifications

General IconGeneral
BrandSiemens
ModelSINAMICS DCM
CategoryMedia Converter
LanguageEnglish

Related product manuals