Siemens SINAMICS DCM - CO: Field Firing Angle after Limiting; Fir Ang Aft Lim; CO: Motorized Potentiometer Output; Motp Outp; CO: Motorized Potentiometer Output Dy;Dt; Motp Outp Dy;Dt; CO: Motorized Potentiometer Setpoint; Motp Set

2 Parameters
2.2 List of parameters
SINAMICS DCM
586 List Manual (LH8), 02/2015, 6RX1800-0ED76
Description: Display and connector output on the motorized potentiometer.
Description: Display and connector output of the dy/dt output on the motorized potentiometer.
Description: Display and connector output of the setpoint on the motorized potentiometer.
Description: Display and connector output for the field firing angle after limiting by the auto-reversing stage.
Description: Displays the field firing angle before limiting by the auto-reversing stage.
r52240 CO: Motorized potentiometer output / MotP outp
DC_CTRL Can be changed: - Calculated: - Access level: 2
Data type: FloatingPoint32 Dyn. index: - Func. diagram: 3110
P-Group: - Unit group: - Unit selection: -
Not for motor type: - Scaling: PERCENT Expert list: 1
Min Max Factory setting
- [%] - [%] - [%]
r52241 CO: Motorized potentiometer output dy/dt / MotP outp dy/dt
DC_CTRL Can be changed: - Calculated: - Access level: 2
Data type: FloatingPoint32 Dyn. index: - Func. diagram: 3110
P-Group: - Unit group: - Unit selection: -
Not for motor type: - Scaling: PERCENT Expert list: 1
Min Max Factory setting
- [%] - [%] - [%]
r52242 CO: Motorized potentiometer setpoint / MotP set
DC_CTRL Can be changed: - Calculated: - Access level: 2
Data type: FloatingPoint32 Dyn. index: - Func. diagram: 3110
P-Group: - Unit group: - Unit selection: -
Not for motor type: - Scaling: PERCENT Expert list: 1
Min Max Factory setting
- [%] - [%] - [%]
r52250 CO: Field firing angle after limiting / Fir ang aft lim
DC_CTRL Can be changed: - Calculated: - Access level: 1
Data type: FloatingPoint32 Dyn. index: - Func. diagram: 6915
P-Group: - Unit group: - Unit selection: -
Not for motor type: - Scaling: PERCENT Expert list: 1
Min Max Factory setting
- [%] - [%] - [%]
r52251 CO: Field firing angle before limiting / Fir ang bef lim
DC_CTRL Can be changed: - Calculated: - Access level: 1
Data type: FloatingPoint32 Dyn. index: - Func. diagram: 6915
P-Group: - Unit group: - Unit selection: -
Not for motor type: - Scaling: PERCENT Expert list: 1
Min Max Factory setting
- [%] - [%] - [%]