Siemens SINAMICS DCM - CO: EMF Setpoint Reduction Output; EMF Setp_Red Outp; CO: Field Voltage Actual Value Absolute Value; Uf Act Abs; CO: Field Voltage Actual Value Signed; Uf Act Val Sign; CO: Output Voltage of the Thyristor Bridge (1 C;1 D); U_Out 1 C;1 D

SINAMICS DCM
List Manual (LH8), 02/2015, 6RX1800-0ED76
593
2 Parameters
2.2 List of parameters
Dependency: Refer to: p50273
Description: Display and connector output for the EMF setpoint reduction.
Dependency: Refer to: p50287, p50288
Description: Display and connector output for the actual value of the field voltage as an absolute value.
Dependency: Refer to: r52296
Note: 100% corresponds to p50078[1] * (3 * sqrt(2)) / Pi.
Description: Display and connector output for the signed actual value of the field voltage.
Dependency: Refer to: r52295
Note: 100% corresponds to p50078[1] * (3 * sqrt(2)) / Pi.
Description: Output voltage of the thyristor bridge (1C/1D) as percentage
(average value between 2 firing pulses)
Note: 100% corresponds to p50078[1] * (3 * sqrt(2)) / Pi.
r52294 CO: EMF setpoint reduction output / EMF setp_red outp
DC_CTRL Can be changed: - Calculated: - Access level: 2
Data type: FloatingPoint32 Dyn. index: - Func. diagram: 6895
P-Group: - Unit group: - Unit selection: -
Not for motor type: - Scaling: PERCENT Expert list: 1
Min Max Factory setting
- [%] - [%] - [%]
r52295 CO: Field voltage actual value absolute value / Uf act abs
DC_CTRL Can be changed: - Calculated: - Access level: 2
Data type: FloatingPoint32 Dyn. index: - Func. diagram: 6902
P-Group: - Unit group: - Unit selection: -
Not for motor type: - Scaling: PERCENT Expert list: 1
Min Max Factory setting
- [%] - [%] - [%]
r52296 CO: Field voltage actual value signed / Uf act val sign
DC_CTRL Can be changed: - Calculated: - Access level: 2
Data type: FloatingPoint32 Dyn. index: - Func. diagram: 6902
P-Group: - Unit group: - Unit selection: -
Not for motor type: - Scaling: PERCENT Expert list: 1
Min Max Factory setting
- [%] - [%] - [%]
r52297 CO: Output voltage of the thyristor bridge (1C/1D) / U_out 1C/1D
DC_CTRL Can be changed: - Calculated: - Access level: 2
Data type: FloatingPoint32 Dyn. index: - Func. diagram: 6902
P-Group: - Unit group: - Unit selection: -
Not for motor type: - Scaling: PERCENT Expert list: 1
Min Max Factory setting
- [%] - [%] - [%]