SINAMICS DCM
List Manual (LH8), 02/2015, 6RX1800-0ED76
455
2 Parameters
2.2 List of parameters
Description: Sets fixed value 13.
Dependency: Refer to: r52413
Note: This value can be interconnected via connector output r52413.
Description: Sets fixed value 14.
Dependency: Refer to: r52414
Note: This value can be interconnected via connector output r52414.
Description: Sets fixed value 15.
Dependency: Refer to: r52415
Note: This value can be interconnected via connector output r52415.
Description: Sets fixed value 16.
Dependency: Refer to: r52416
Note: This value can be interconnected via connector output r52416.
p50413[0...n] Fixed value 13 / Fix val 13
DC_CTRL Can be changed: U, T Calculated: - Access level: 2
Data type: FloatingPoint32 Dyn. index: DDS, p0180 Func. diagram: 3100
P-Group: - Unit group: - Unit selection: -
Not for motor type: - Scaling: PERCENT Expert list: 1
Min Max Factory setting
-340.28235E36 [%] 340.28235E36 [%] 0.00 [%]
p50414[0...n] Fixed value 14 / Fix val 14
DC_CTRL Can be changed: U, T Calculated: - Access level: 2
Data type: FloatingPoint32 Dyn. index: DDS, p0180 Func. diagram: 3100
P-Group: - Unit group: - Unit selection: -
Not for motor type: - Scaling: PERCENT Expert list: 1
Min Max Factory setting
-340.28235E36 [%] 340.28235E36 [%] 0.00 [%]
p50415[0...n] Fixed value 15 / Fix val 15
DC_CTRL Can be changed: U, T Calculated: - Access level: 2
Data type: FloatingPoint32 Dyn. index: DDS, p0180 Func. diagram: 3100
P-Group: - Unit group: - Unit selection: -
Not for motor type: - Scaling: PERCENT Expert list: 1
Min Max Factory setting
-340.28235E36 [%] 340.28235E36 [%] 0.00 [%]
p50416[0...n] Fixed value 16 / Fix val 16
DC_CTRL Can be changed: U, T Calculated: - Access level: 2
Data type: FloatingPoint32 Dyn. index: DDS, p0180 Func. diagram: 3100
P-Group: - Unit group: - Unit selection: -
Not for motor type: - Scaling: PERCENT Expert list: 1
Min Max Factory setting
-340.28235E36 [%] 340.28235E36 [%] 0.00 [%]
To Next Page
Loading...
