Siemens SINAMICS DCM - Parallel Interface CAN Diagnostic Information; PI CAN Diag Info; Parallel Interface Transmit Data Display; PI Trans Data Disp

SINAMICS DCM
List Manual (LH8), 02/2015, 6RX1800-0ED76
549
2 Parameters
2.2 List of parameters
Description: Displays the CAN diagnostic information for the parallel interface.
Description: Displays the data selected for transmission.
Index: [0] = Word 1
[1] = Word 2
[2] = Word 3
[3] = Word 4
[4] = Word 5
[5] = Word 6
[6] = Word 7
[7] = Word 8
[8] = Word 9
[9] = Word 10
[10] = Word 11
[11] = Word 12
[12] = Word 13
[13] = Word 14
[14] = Word 15
[15] = Word 16
r51811 Parallel interface CAN diagnostic information / PI CAN diag info
DC_CTRL Can be changed: - Calculated: - Access level: 1
Data type: Unsigned16 Dyn. index: - Func. diagram: 9350
P-Group: - Unit group: - Unit selection: -
Not for motor type: - Scaling: - Expert list: 1
Min Max Factory setting
- - -
Bit field: Bit Signal name 1 signal 0 signal FP
00 Abort acknowledge flag 9350
01 Write denied flag 9350
02 Wake-up flag 9350
03 Received msg lost flag 9350
04 Bus-off condition flag 9350
05 Error passive mode flag 9350
06 Warning level flag 9350
07 Form error flag 9350
08 Bit error flag 9350
09 Stuck at dominant bit 9350
10 CRC error 9350
11 Stuff bit error 9350
12 ACK error 9350
13 Bus-off status 9350
14 Error passive state 9350
15 Warning status 9350
r51813[0...15] Parallel interface transmit data display / PI trans data disp
DC_CTRL Can be changed: - Calculated: - Access level: 1
Data type: Unsigned16 Dyn. index: - Func. diagram: 9355
P-Group: - Unit group: - Unit selection: -
Not for motor type: - Scaling: - Expert list: 1
Min Max Factory setting
- - -