Siemens SINAMICS DCM List Manual

2 Parameters
2.2 List of parameters
SINAMICS DCM
548 List Manual (LH8), 02/2015, 6RX1800-0ED76
Description: Sets the signal source for triggering fault F60014 "Telegram monitoring timeout".
The fault is triggered on a 1 signal.
Dependency: Refer to: r53310
Refer to: F60014
Description: Displays the diagnostic information for the parallel interface.
Index: [0] = Telegrams transmitted without errors
[1] = Telegrams received without errors
[2] = Transmission error
[3] = Receive error
[4] = Timeouts
Dependency: Refer to: p51807
Note: The counters are reset to 0 at POWER ON.
The counters restart at 0 after reaching a value of 65535.
Description: Displays the activities on the individual stations on the parallel interface.
p51808 BI: Parallel interface signal source for F60014 / P IF F60014 sig s
DC_CTRL Can be changed: T Calculated: - Access level: 2
Data type: Unsigned32 / Binary Dyn. index: - Func. diagram: 9350
P-Group: - Unit group: - Unit selection: -
Not for motor type: - Scaling: - Expert list: 1
Min Max Factory setting
- - 53310.0
r51809[0...4] Parallel interface diagnostic information / Par IF diag info
DC_CTRL Can be changed: - Calculated: - Access level: 1
Data type: Unsigned16 Dyn. index: - Func. diagram: 9350
P-Group: - Unit group: - Unit selection: -
Not for motor type: - Scaling: - Expert list: 1
Min Max Factory setting
- - -
r51810 Parallel interface activity display / Par IF act disp
DC_CTRL Can be changed: - Calculated: - Access level: 1
Data type: Unsigned16 Dyn. index: - Func. diagram: 9350
P-Group: - Unit group: - Unit selection: -
Not for motor type: - Scaling: - Expert list: 1
Min Max Factory setting
- - -
Bit field: Bit Signal name 1 signal 0 signal FP
00 Station 1 transmitting data Yes No -
01 Station 2 transmitting data Yes No -
02 Station 3 transmitting data Yes No -
03 Station 4 transmitting data Yes No -
04 Station 5 transmitting data Yes No -
05 Station 6 transmitting data Yes No -
06 Station 7 transmitting data Yes No -
07 Station 8 transmitting data Yes No -
08 Station 9 transmitting data Yes No -
09 Station 10 transmitting data Yes No -
10 Station 11 transmitting data Yes No -
11 Station 12 transmitting data Yes No -
12 Station 13 transmitting data Yes No -
13 Station 14 transmitting data Yes No -
14 Station 15 transmitting data Yes No -
15 Station 16 transmitting data Yes No -

Siemens SINAMICS DCM Specifications

General

Brand	Siemens
Model	SINAMICS DCM
Category	Media Converter
Language	English