SINAMICS DCM
List Manual (LH8), 02/2015, 6RX1800-0ED76
435
2 Parameters
2.2 List of parameters
Description: Sets the smoothing time for the line voltage for the EMF setpoint reduction.
Dependency: Refer to: p50286, p50287, p50288, p50289, r52294
Description: Sets the upper limit for the line voltage for EMF setpoint reduction.
Dependency: Refer to: p50287, p50288, p50289, r52294
Description: Sets the lower limit for the line voltage for the EMF setpoint reduction.
Dependency: Refer to: p50286, p50288, p50289, r52294
Description: Sets the evaluation factor for the EMF setpoint reduction.
Dependency: Refer to: p50286, p50287, p50289, r52294
Description: Sets the signal source to activate the EMF setpoint reduction.
Dependency: Refer to: p50285, p50286, p50287, p50288, r52294
p50285[0...n] EMF setpoint reduction line voltage smoothing time / EMF set line t_sm
DC_CTRL Can be changed: U, T Calculated: - Access level: 2
Data type: FloatingPoint32 Dyn. index: DDS, p0180 Func. diagram: 6895
P-Group: - Unit group: - Unit selection: -
Not for motor type: - Scaling: - Expert list: 1
Min Max Factory setting
0.00 [s] 10.00 [s] 0.00 [s]
p50286[0...n] EMF setpoint reduction line voltage upper limit / EMF set line upper
DC_CTRL Can be changed: U, T Calculated: - Access level: 2
Data type: FloatingPoint32 Dyn. index: DDS, p0180 Func. diagram: 6895
P-Group: - Unit group: - Unit selection: -
Not for motor type: - Scaling: PERCENT Expert list: 1
Min Max Factory setting
100.0 [%] 150.0 [%] 110.0 [%]
p50287[0...n] EMF setpoint reduction line voltage lower limit / EMF set line lower
DC_CTRL Can be changed: U, T Calculated: - Access level: 2
Data type: FloatingPoint32 Dyn. index: DDS, p0180 Func. diagram: 6895
P-Group: - Unit group: - Unit selection: -
Not for motor type: - Scaling: PERCENT Expert list: 1
Min Max Factory setting
0.0 [%] 100.0 [%] 0.0 [%]
p50288[0...n] EMF setpoint reduction evaluation factor / EMF set eval_fact
DC_CTRL Can be changed: U, T Calculated: - Access level: 2
Data type: FloatingPoint32 Dyn. index: DDS, p0180 Func. diagram: 6895
P-Group: - Unit group: - Unit selection: -
Not for motor type: - Scaling: PERCENT Expert list: 1
Min Max Factory setting
0.0 [%] 200.0 [%] 100.0 [%]
p50289[0...n] BI: EMF setpoint reduction activation signal source / EMF set act sig s
DC_CTRL Can be changed: T Calculated: - Access level: 2
Data type: Unsigned32 / Binary Dyn. index: CDS, p0170 Func. diagram: 6895
P-Group: - Unit group: - Unit selection: -
Not for motor type: - Scaling: - Expert list: 1
Min Max Factory setting
- - 0
To Next Page
Loading...
