SINAMICS DCM
List Manual (LH8), 02/2015, 6RX1800-0ED76
581
2 Parameters
2.2 List of parameters
Description: Display and connector output for the default value of variable negative main setpoint limiting with index 0.
Dependency: Refer to: p50642
Note: The value represents the inversion of p50642[0].
Description: Display and connector output for the default value of variable negative main setpoint limiting with index 1.
Dependency: Refer to: p50642
Note: The value represents the inversion of p50642[1].
Description: Display and connector output for the default value of variable negative main setpoint limiting with index 2.
Dependency: Refer to: p50642
Note: The value represents the inversion of p50642[2].
Description: Display and connector output for the default value of variable negative main setpoint limiting with index 3.
Dependency: Refer to: p50642
Note: The value represents the inversion of p50642[3].
r52184 CO: Setpoint processing main setpoint lim neg default 0 / M set neg def 0
DC_CTRL Can be changed: - Calculated: - Access level: 2
Data type: FloatingPoint32 Dyn. index: - Func. diagram: 3135
P-Group: - Unit group: - Unit selection: -
Not for motor type: - Scaling: PERCENT Expert list: 1
Min Max Factory setting
- [%] - [%] - [%]
r52185 CO: Setpoint processing main setpoint lim neg default 1 / M set neg def 1
DC_CTRL Can be changed: - Calculated: - Access level: 2
Data type: FloatingPoint32 Dyn. index: - Func. diagram: 3135
P-Group: - Unit group: - Unit selection: -
Not for motor type: - Scaling: PERCENT Expert list: 1
Min Max Factory setting
- [%] - [%] - [%]
r52186 CO: Setpoint processing main setpoint lim neg default 2 / M set neg def 2
DC_CTRL Can be changed: - Calculated: - Access level: 2
Data type: FloatingPoint32 Dyn. index: - Func. diagram: 3135
P-Group: - Unit group: - Unit selection: -
Not for motor type: - Scaling: PERCENT Expert list: 1
Min Max Factory setting
- [%] - [%] - [%]
r52187 CO: Setpoint processing main setpoint lim neg default 3 / M set neg def 3
DC_CTRL Can be changed: - Calculated: - Access level: 2
Data type: FloatingPoint32 Dyn. index: - Func. diagram: 3135
P-Group: - Unit group: - Unit selection: -
Not for motor type: - Scaling: PERCENT Expert list: 1
Min Max Factory setting
- [%] - [%] - [%]
To Next Page
Loading...
